Local Generator Installation in Richlandtown, PA

Power goes out somewhere in upper Bucks County every winter, and houses with a standby generator are the ones where nobody has to go looking for flashlights.

Whole-Home Generator Installation Built Around Your Richlandtown House

Here’s where a standby generator job goes sideways. Someone sizes it off a quick glance at your panel instead of a real load calculation, and you either pay for a bigger unit than you’ll ever use or end up with one that trips at the first outage.

At Crosswyre Electric, we figure out which circuits matter to you, whether that’s the whole house or just the heat, the fridge, the sump pump, and a few outlets. Then, we size a Generac standby unit to carry exactly that.

The generator sits on a pad outside, ties into your gas or propane line, and connects through an automatic transfer switch that flips within seconds of an outage, whether you’re home or not.

We’re a family-run electrical shop out of Coopersburg with 45-plus years of combined experience, and we’ve been wiring up the Lehigh Valley and upper Bucks for over 17 of them.

We install Generac and only Generac, so we know these units up close and personal, from the sizing to the weekly self-test they run on their own.

Why Richlandtown Homeowners Choose Crosswyre Electric

A Look at Our Recent Generator Installations

Here are a few of the standby systems we’ve set and wired for homeowners around the Valley.

750+

Electrical Repairs Completed

1,000+

Residential Projects Done

45+

Years of Electrical Expertise

What Richlandtown Neighbors Are Saying

Most folks tell us the best part is how little they think about the generator after we leave, which is exactly the point.

Kim Helmle

Rated 5 out of 5

The Crosswyre Team is top notch! Superb Customer Service, very polite, friendly, and professional. The quality of their work is excellent. Their pricing is fair and reasonable. They initially replaced an outdoor motion light.

I was so impressed that I asked about having a standby generator installed. Gerad took the time to understand my needs and made recommendations for what would work best for my home and budget. I highly recommend them for any electrical needs you may have.

So, What Does a Standby Generator Cost?

We price generators flat-rate, so the number you get up front covers the unit, the transfer switch, the pad, and the permit, with no surprise add-ons at the end.

Portable setups range from $1,000 to $2,000 and cover smaller needs with a manual hookup.
Whole-home standby systems run $10,000 to $17,000 installed, depending on the unit size and how your gas and electrical tie in.
Most standby jobs we do fall in the $13,500 to $14,500 range, which is a typical 18kW to 24kW Generac sized for a full house.

Where a whole-home job lands mostly comes down to the kilowatt size you need and the fuel and wiring runs at your place.

If you want the generator to start reliably for years, our maintenance plan costs $275 a year and covers the battery, spark plugs, oil, and filters.

How the Install Works

Assessment

We walk the house with you, and you get a real kilowatt number based on your house, not a guess off the panel door.

Quote

You get one written price covering the Generac unit, the transfer switch, the pad, and the permit.

Install

We set the generator, wire the automatic transfer switch, and tie in the fuel.

What You Get With Crosswyre

Generac, and only Generac

We install one standby brand so we know it inside and out, from sizing the unit to programming the weekly self-test it runs on its own. That’s why our installs tend to pass inspection the first time.

We handle the permit and the inspection

We pull the electrical permit with the borough, and we’re on-site when the inspector comes through. You don’t chase paperwork or schedule anything with the code office.

We’re still around after install day

Our maintenance plan covers the battery, spark plugs, oil, and filters, which are the parts that quietly decide whether a 5-year-old generator actually fires up when the storm finally hits.

You can read how we keep these units healthy in our generator maintenance guide.

Generator Installation FAQs

How big a generator do I actually need?

It depends on what you want to keep running. A whole-house system can run everything, including central AC and the well pump, while a smaller unit can cover essentials like heat, the fridge, and a few outlets. We size it during the load assessment so you don’t overpay for capacity you’ll never use.

Do I need a permit for a standby generator in Richlandtown?

Yes, a standby install needs an electrical permit, and depending on the fuel line, it may need a mechanical permit, too. We pull the borough permit and handle the inspection as part of the job.

How long does the installation take?

The electrical side is usually a single day once the unit and materials are on hand. If we need to run a gas line or propane tank, that adds a little time and sometimes a second trade, and we’ll lay all of that out in the quote.

Where does the generator get its fuel?

Generac standby units run on natural gas or propane, so we tie into whichever you already have. If you’re on propane, your tank size affects how long the generator can run, and we’ll talk that through during the walk.

Will it really turn on by itself when the power goes out?

Yes. The automatic transfer switch senses the outage and starts the generator within seconds, then switches back and shuts it down once the grid returns. You don’t have to be home or lift a finger.

Is a portable unit or a standby system the better fit for me?

A portable unit costs less up front and works if you only need to power a few things and don’t mind running cords and refueling it by hand. A permanent standby system carries more, starts on its own, and stays put. The right choice really comes down to how much of the house you want covered and how hands-off you want to be.

A Standby Generator Turns an Outage Into a Non-Event

Gerad Crosswy

We’ll walk your property, size a Generac standby system around the circuits you actually care about, and give you a flat-rate number before anything gets ordered.

You can see the full rundown on our generator installation page and get on the schedule before the winter storms roll in. Call us at (610) 214-2179 or contact us here.

(takes 1-2 min)

Richlandtown is a small borough up in the northern corner of Bucks County, sitting just off Route 212 a few minutes from Quakertown. It’s close enough to Nockamixon State Park for an easy weekend trip, and far enough into open country that the weather has some teeth. Summer thunderstorms roll through hard, and winter brings the nor’easters and ice storms that drag lines down and leave whole streets dark for a day or more. That combination is exactly why a standby generator makes sense in this part of the Valley, since outages here aren’t rare and they aren’t always short. Electrical permits go through the Richlandtown Borough office, and we handle the filing and inspection as part of every install.